NOTE: Be sure to turn the power off to your machine before proceeding!
Installing the power for your Scorbitron is easy in three steps:
- Locating your power source
- Installing any necessary adapters and cabling to the source
- Connecting the power cable to your Scorbitron
Locating Your Power Source
Identify position CN6 on your Stern Spike 2 power driver board. This illustration should guide you to its location:
Installing the Power Adapter
Note: As with any pinball modification, it is possible that making changes to a Stern pinball game may void the game's warranty and/or may be a violation of the Stern software license. Please consult your manufacturer's information for details.
Insert the supplied Stern Spike 2 power cable's white 3-pin connector into CN6 in the direction shown here:
Connect Power Cable to Scorbitron
Routing the power cable carefully through the machine's existing wire management, run the power cable to the power input connector of the Scorbitron:
The Scorbitron is now ready to receive power, so now you may proceed to the next step, connecting your game data to the Scorbitron.
Please refer to the next section, Connecting Your Game to the Scorbitron.