NOTE: Be sure to turn the power off to your machine before proceeding!
Installing the power for your Scorbitron is easy in three steps:
- Locating your power source
- Installing any necessary adapters and cabling to the source
- Connecting the power cable to your Scorbitron
Locating Your Power Source
Identify position CN2 on your Stern Whitestar MPU board. This illustration should guide you to its location:
Installing the Power Adapter
Remove the existing cable connector attached to CN2 and push aside, noting which direction the connector is facing. Next, insert the supplied Stern Whitestar power adapter's white 6-pin connector into CN2 in the manner shown here:
Attach the original cable and connector that was previously connected to CN2 into the 6-pin output connector of the power adapter as shown here:
Connect Power Cable to Scorbitron
Attach the provide Scorbitron power cable to the 4 pin output connector as shown here:
Routing the power cable carefully through the machine's existing wire management, run the power cable to the power input connector of the Scorbitron:
The Scorbitron is now ready to receive power, so now you may proceed to the next step, connecting your game data to the Scorbitron.
Please refer to the next section, Connecting Your Game to the Scorbitron.