NOTE: Be sure to turn the power off to your machine before proceeding!
Installing the power for your Scorbitron is easy in three steps:
- Locating your power source
- Installing any necessary adapters and cabling to the source
- Connecting the power cable to your Scorbitron
Locating Your Power Source
Identify position J138, J140 and J141 on your WPC-95 power driver board. This illustration should guide you to the location:
Installing the Power Adapter
You have two options at this point:
OPTION 1: EMPTY CONNECTOR AVAILABLE AT J138, J140, J141
If one of the three connectors (J138, J140 or J141) is not being used, you can connect the Scorbitron power cable directly to the WPC power driver board to any of the three connectors and skip to the final step (connecting the cable to the Scorbitron), as shown here:
OPTION 2: NO CONNECTOR AVAILABLE AT J138, J140, J141
If no connector is available, you will need to use the WPC power adapter supplied with your Scorbitron. Remove the existing cable connector attached to either J138, J140 or J141 and push aside, noting which direction the connector is facing. We have found that J141 provides the most room for this installation, but any of them should work. Next, insert the supplied WPC power adapter's white 4-pin connector into one of the connectors in the manner shown here:
Attach the original cable and connector that was previously connected to J116, J117 or J118 into the 4-pin output connector of the power adapter as shown here:
Connect Power Cable to Scorbitron
Attach the provided Scorbitron power cable to the 4-pin output connector as shown here:
Routing the power cable carefully through the machine's existing wire management, run the power cable to the power input connector on the Scorbitron:
The Scorbitron is now ready to receive power, so now you may proceed to the next step, connecting your game data to the Scorbitron.
Please refer to the next section, Connecting Your Game to the Scorbitron.