Skip to content

Stern Spike 1 Power Installation

NOTE: Be sure to turn the power off to your machine before proceeding!

Installing the power for your Scorbitron is easy in three steps:

  1. Locating your power source
  2. Installing any necessary adapters and cabling to the source
  3. Connecting the power cable to your Scorbitron

Locating Your Power Source

Identify position CN24 on your Stern Spike 1 MPU board. This illustration should guide you to its location:

step_3_stern_spike_1_smaller.gif

Installing the Power Adapter

Remove the existing cable connector attached to CN24 and push aside, noting which direction the connector is facing. Next, insert the supplied Stern Spike 1 Power Adapter's white 4-pin connector into CN24 in the orientation shown here:

step_4_spike_1.jpg

Attach the original cable and connector that was in CN24 into the 4-pin output connector of the power adapter as shown here:

step_5_spike_1.jpg

Connect Power Cable to Scorbitron

Attach the provide Scorbitron power cable to the 4 pin output connector as shown here:

step_6_spike_1.jpg

Routing the power cable carefully through the machine's existing wire management, run the power cable to the power input connector of the Scorbitron:

step_6a_all.jpg

The Scorbitron is now ready to receive power, so now you may proceed to the next step, the Game Data Connection.