NOTE: Be sure to turn the power off to your machine before proceeding!
Installing the power for your Scorbitron is easy in three steps:
- Locating your power source
- Installing any necessary adapters and cabling to the source
- Connecting the power cable to your Scorbitron
Locating Your Power Source
Identify position J3 on your Capcom power board. This illustration should guide you to its location:
Installing the Power Adapter
Remove the existing cable connector attached to J3 and push aside, noting its orientation. Next, insert the supplied Capcom Power Adapter's white 5-pin connector into J3 in the orientation shown here:
Attach the original cable and connector that was in J3 into the 5-pin output connector of the power adapter as shown here:
Connect Power Cable to Scorbitron
Attach the provide Scorbitron power cable to the 4 pin output connector as shown here:
Routing the power cable carefully through the machine's existing wire management, run the power cable to the power input connector of the Scorbitron:
The Scorbitron is now ready to receive power, so now you may proceed to the next step, connecting your game data to the Scorbitron.
Please refer to the next section, Connecting Your Game to the Scorbitron.