Data East / Sega Power Installation

NOTE: Be sure to turn the power off to your machine before proceeding!

Installing the power for your Scorbitron is easy in three steps:

1. Locating your power source

2. Installing any necessary adapters and cabling to the source

3. Connecting the power cable to your Scorbitron

Locating Your Power Source

Identify position CN2 on your Data East or Sega MPU board. This illustration should guide you to its location:

Sega / Data East Power Location

Installing the Power Adapter

Remove the existing cable connector attached to CN2 and push aside, noting which direction the connector is facing. Next, insert the supplied Data East / Sega power adapter's white 6-pin connector into CN2 in the manner shown here:

Data East / Sega with Power Adapter

Attach the original cable and connector that was previously connected to CN2 into the 6-pin output connector of the power adapter as shown here:

Data East / Sega Original Power Cable on Adapter

Connect Power Cable to Scorbitron

Attach the provide Scorbitron power cable to the 4 pin output connector as shown here:

Data East / Sega Power Adapter Fully Installed

Routing the power cable carefully through the machine's existing wire management, run the power cable to the power input connector of the Scorbitron:

step_6a_all.jpg

The Scorbitron is now ready to receive power, so now you may proceed to the next step, the Game Data Connection.