Stern Spike 1 Power Installation
Last updated
Last updated
NOTE: Be sure to turn the power off to your machine before proceeding!
Installing the power for your Scorbitron is easy in three steps:
Locating your power source
Installing any necessary adapters and cabling to the source
Connecting the power cable to your Scorbitron
Identify position CN24 on your Stern Spike 1 MPU board. This illustration should guide you to its location:
Remove the existing cable connector attached to CN24 and push aside, noting which direction the connector is facing. Next, insert the supplied Stern Spike 1 Power Adapter's white 4-pin connector into CN24 in the orientation shown here:
Attach the original cable and connector that was in CN24 into the 4-pin output connector of the power adapter as shown here:
Attach the provide Scorbitron power cable to the 4 pin output connector as shown here:
Routing the power cable carefully through the machine's existing wire management, run the power cable to the power input connector of the Scorbitron:
The Scorbitron is now ready to receive power, so now you may proceed to the next step, the Game Data Connection.
