Early Bally (-35, -17, -133) and Stern (MPU-100/200) Power Installation
Last updated
Last updated
NOTE: Be sure to turn the power off to your machine before proceeding!
Installing the power for your Scorbitron is easy in three steps:
Locating your power source
Installing any necessary adapters and cabling to the source
Connecting the power cable to your Scorbitron
Identify position J4 on your Bally Stern MPU board. This illustration should guide you to its location:
Remove the existing cable connector attached to J4 and push aside, noting its orientation. Next, insert the supplied early Bally / Stern power adapter into J4 in the orientation shown here:
Attach the original cable and connector that was in J4 into the 28-pin output connector of the power adapter as shown here:
Attach the provide Scorbitron power cable to the 4 pin output connector as shown here:
Routing the power cable carefully through the machine's existing wire management, run the power cable to the power input connector of the Scorbitron:
The Scorbitron is now ready to receive power, so now you may proceed to the next step, the Game Data Connection.
